BS - 8110 - Coupler Testing Specification and Criteria

-

Coupler testing Specification, Criteria and Standards as per BS 8110

British Code - BS 8110 - Structural use of concrete

BS 8110

Type of Test Required

Why !

(purpose of the test)

What is the Criteria ?

Static tensile strength test

Tensile strength of the Rebar joint

(Rebar to Coupler Splice) joint

 

> 1.15fy

&

Bar break (100%fu)

 

Slip Test

 


Used to make sure that the plastic movement (slip) between the reinforcement bars with in the Mechanical Splice, when Loaded in tension



<=0.10mm after applying 0.6fy loading

 


Maximum % Elongation

 

 

0.1 mm after applying 0.6 fy loading

 

BS 8110

British Code has lower acceptance criteria as compared to the ACI code, 

It specifies tensile testing and slip test for the joint for acceptance of the sample.



Comments

Post a Comment

Popular posts from this blog

IS 16172-2014 - Standard for Reinforcement Couplers for Mechanical Splices of Bars in Concrete - Specifications

-
Image
IS 16172:2014 Reinforcement Couplers for Mechanical Splices of Bars in Concrete - Specifications Class H  – Couplers which meet both Low cyclic fatigue test and high cyclic fatigue test requirements shall be classified and Designated as  Class H Couplers Class L  – All other Coupler which meets only low cycle fatigue requirements shall be designated as  Class L Couplers   Grade Fy (yield strength) Fu (Ultimate Strength) % Elongation of Bar (min) Fe 500 500 N/mm^2 545 N/ mm^2 12% Fe 500D 500 N/ mm^2 565 N/ mm^2 16% Fe 550 550 N/ mm^2 585 N/ mm^2 10% Fe 550 550 N/ mm^2 600 N/ mm^2 14.5% Fe 600 600 N/ mm^2 660 N/ mm^2 10%     IS 16172 :2014   ...
Read more

ACI 318 / ACI 133 - Coupler Codes and Standard in Building code Requirements for Structural Concrete and Commentary

-
Image
American Concrete Institute (ACI) Building Code 318 - Building code Requirements for Structural Concrete and Commentary ACI 318 / ACI 133 A CI 318 / ACI 133 Type of Test Required Why ! (purpose of the test) What is the Criteria ? Static tensile strength test Tensile strength of the Rebar joint (Rebar to Coupler Splice) joint   > 1.25fy for Type 1 100% fu & >1.25fy for Type 2   Fu = Ultimate Strength of bar Fy = Yield Strength of bar   Slip Test   Used to make sure that the plastic movement (slip) between the reinforcement bars with in the Mechanical Splice, when Loaded in tension   The bar-splice assembly shall be loaded in tension to nominal zero load, not exceeding 4Mpa (600 psi).   The bar-splice assembly then be loaded in tension with a loading rate between 70 Mpa/min to 690 Mpa/min.   ...
Read more